Operating Precautions for the CNC Rebar Cage Spiral Winding Machine

Source: Zhongyi Heavy Industry Release Date：2022-10-28

Views：39

In recent years, continuous advances in technology have brought an increasing number of intelligent rebar processing machines to the market, and the rebar cage spiral winding machine is one such product of modern innovation. Since its introduction, the machine has undergone constant refinement, and its processing quality has become increasingly stable, earning wide recognition from industry professionals. As intelligent equipment, however, it still requires careful handling in a number of areas. Here, Zhongyi will guide you through them in detail, starting with installation.

I. Installation Precautions

Before installing the rebar cage spiral winding machine, make sure you have a clear understanding of the equipment and its installation procedure, and anticipate potential problems that may arise during the process.Prepare all required installation tools in advance, and handle the equipment with care to avoid damage that could affect normal operation.During installation, keep unrelated personnel away from the site, and check and level the equipment to keep it in good condition and ensure efficient operation.

II. Processing Precautions

When processing, note that the stirrups (spiral hoops) at both ends of the rebar cage should be wound together. Therefore, set the pitch value correctly and keep the processing deviation under control.At points where the main bars and stirrups have rusted, or where they are deformed or twisted, the rotation of the main turntable may be affected. Check the rotating condition on a regular basis.After the cage has been fully wound, start the gantry crane to lift the entire cage to a level position before raising the joint. This prevents the cage from striking the welding joint when it is removed.

III. Storage Precautions

Most importantly, the machine should be stored in a dry indoor area. If it must be kept outdoors, place it on wooden planks and cover it properly.Before storage, inspect the whole machine for any signs of damage. Repair any damage found and confirm the machine is free of faults before putting it into storage.Before storage, clean the machine, set the fuel (throttle) control lever to the idle position, and place the operating lever in neutral.

We hope the above precautions for using the CNC rebar cage spiral winding machine are helpful. For more information on the equipment, please feel free to contact Zhongyi Heavy Industry (Shandong) Co., Ltd.